How to Set Up a DoubleNest Hammock With a Hammock Stand Bundle

Quick answer

To set up a DoubleNest Hammock on a stand, assemble the stand on level ground, attach the hammock's straps or suspension to the stand's attachment points, and aim for a gentle sag of about 30 degrees. If your bundle includes a Hammock Hanging Kit, use it only for secure wooden structures such as posts or beams, not for the stand itself. Check all connections by hand before you sit down.

A hammock stand bundle takes the guesswork out of finding two trees, but the setup still has a few details that decide whether you nap or slide. The DoubleNest Hammock is spacious enough for two and made with soft FreeWave fabric, so it rewards a little care at the stand.

This guide walks through assembling the stand, hanging the DoubleNest, and knowing when to add accessories like the Hammock Hanging Kit or the TravelNest Hammock + Straps Combo. Each step includes the one mistake that most often causes a wobbly or uncomfortable hang.

Before you start: pick the right spot and check your bundle

Set up on flat, firm ground. Grass, decking, or patio pavers all work if the surface does not shift under weight. Clear the area of rocks, sprinkler heads, and low branches, and keep at least a few feet of open space at each end of the stand so you can walk around it while attaching the hammock.

Unpack the bundle and lay out every part: stand tubes or arms, any hardware, the hammock, and the suspension. If your bundle includes a Hammock Hanging Kit, set it aside for now. That kit is designed to hang a hammock from a secure wooden structure, not to connect a hammock to a stand, so mixing the two can leave you short on the right connection.

• Common mistake: assembling a stand on soft, uneven ground, which makes the whole setup feel unstable before the hammock is even attached.
• Checkpoint: with the stand assembled but empty, press down on each end. It should not rock or sink.

Assemble the stand and confirm the attachment points

Follow the stand's included instructions in order, hand-tightening bolts or pins first and then going back to snug them once the frame is square. Many stand designs use a few main tubes plus cross supports, and skipping a step usually shows up later as a crooked frame or a hammock that hangs off-center.

Once the frame is together, locate the hammock attachment points at each end. These are where your straps or suspension will connect. If your stand has multiple height or position options, start in the middle setting so you have room to adjust after the first test hang.

• Common mistake: overtightening hardware before the frame is fully aligned, which can strip threads or bend a joint.
• Checkpoint: the stand should sit level, with both attachment points at the same height.

Attach the DoubleNest Hammock to the stand

The DoubleNest Hammock is sold with color options, and it uses ENO's FreeWave fabric for a soft, durable feel. Connect your suspension to the hammock's end loops, then attach the other end to the stand's attachment points. If your bundle includes the TravelNest Hammock + Straps Combo, that setup is designed to go up in a flash and includes everything you need to hang on the go, so it can serve as a second hammock for a guest or a travel option.

Work from one end to the other, keeping the hammock roughly centered. A hammock that is pulled tight like a banjo string will feel tippy and uncomfortable, so leave a visible curve in the fabric before you climb in.

• Common mistake: attaching the hammock so tightly that it has no sag, which increases pressure on the stand and makes it harder to get comfortable.
• Checkpoint: the hammock should hang with a gentle, even curve from end to end.

Set the hang angle and test it safely

A common target for a comfortable hang is about 30 degrees from horizontal, which usually means the hammock sits lower than you might expect. Sit down gently first, then swing your legs in. If you feel like you are sliding toward the middle or the hammock feels unstable, lower the attachment points or loosen the suspension slightly.

Test the setup with your full weight before you settle in for a long hang. Rock side to side a little and listen for creaks or shifting. If anything moves that should not, get out and recheck the connections.

• Common mistake: jumping into a newly hung hammock instead of easing in, which is how most tip-overs happen.
• Checkpoint: the hammock holds steady when you shift your weight, and the stand stays planted.

When to use a hanging kit or a second hammock

If you want to hang the same DoubleNest from a wooden post, beam, or gazebo instead of the stand, the Hammock Hanging Kit is the right accessory. It is made for secure wooden structures from basement to bedroom and patio to gazebo, so it is a good option when you have a solid wooden anchor but no trees. Do not use it on the stand itself.

For camping or travel, the TravelNest Hammock + Straps Combo includes the hammock and straps together, which keeps packing simple. Pairing it with the DoubleNest gives you a lightweight option for trips and a roomier option for the backyard.

• Common mistake: assuming any strap or kit works with any anchor. Match the accessory to the structure it was designed for.
• Checkpoint: before each hang, confirm the anchor point is solid and the hardware is fully engaged.

Setup steps at a glance

1. Choose and clear a level spot: Set up on firm, flat ground and remove anything that could poke or trip you around the stand. Checkpoint: the stand does not rock when you press on each end.
2. Assemble the stand in order: Follow the stand instructions, hand-tighten first, then snug hardware once the frame is square. Common mistake: overtightening before the frame is aligned.
3. Attach the DoubleNest with the right suspension: Connect your straps or suspension to the hammock loops and the stand's attachment points, keeping the hammock centered. Checkpoint: the hammock hangs with a gentle curve, not pulled tight.
4. Adjust for about 30 degrees of sag: Lower or loosen the attachment points until the hammock sits with a comfortable sag and does not slide you toward the middle. Common mistake: hanging too tight, which feels tippy.
5. Test with your full weight: Sit in gently, then shift your weight and listen for movement before you settle in. Checkpoint: no creaks, shifting, or wobble from the stand.
6. Add a hanging kit or second hammock only where it fits: Use the Hammock Hanging Kit on secure wooden structures, and keep the TravelNest Combo for travel or a guest hang. Do not use the hanging kit on the stand itself.

Product facts that affect your setup

• DoubleNest® Hammock: Spacious enough for two, the award-winning ENO DoubleNest Hammock is expertly constructed with durable yet soft FreeWave® fabric. The two-person capacity and soft fabric mean you can share the hang, but you still need a stand and suspension rated for the weight and width of two people.
• Hammock Hanging Kit: When you want to relax at home, the ENO Hammock Hanging Kit lets you safely hang your hammock using any secure wooden structure from basement to bedroom, patio to gazebo. This kit is for wooden structures, not for attaching a hammock to a stand, so it is a separate option for indoor or porch hangs.
• TravelNest® Hammock + Straps Combo: Your go-to hammock for any adventure, the ENO TravelNest sets up in a flash and includes everything you need to comfortably hang out on the go. If you want a second hammock for travel or a guest, this combo includes straps so you do not need to buy them separately.

A hammock stand bundle is only as relaxing as its setup. Take ten minutes to level the ground, assemble the frame correctly, and dial in the sag, and your DoubleNest will feel stable and comfortable every time you climb in. Keep the Hammock Hanging Kit for wooden structures and the TravelNest Combo for trips, and you will always have the right hang for the spot.